Specification:Working Area: 300x240mm;Weight: 8kgs;Height: 0-120mm adjustable ;Left-Right Adjustable: -10-----+10mm ;Front-Rear Adjustable: 0-10mm;Installation and maintenanceInstall: Refer to the install guideMaintenance: Add grease to the stencil bracket lifting motion/screw rod/ transimission motion on a regular basis.PrintingA. Put the stencil on the stencil bracket (2) after cleaning stencil, adjust the embossingstar knob (3) to suitable location, then fixed it.B. Install PCB positioning block (11) and PCB fixation unit (5). Referring to the positionof the positioning hole PCB board position to adjust the distance of the PCB and stencil holderand fixed (if PCB board is big, need to use support pin (9),Support pin should select the appropriate threadedhole screwed)(1) 3)Rotate the upper and lower adjusting handle (1) to adjust the height of stencil bracket. Rotate X-axis adjusting handle (6) and Y-axis adjusting handle (7) to adjust the relative position of the PCB and stencil (If you can notadjust the relative position within the full stroke, move the stencil position), if angulardifference between PCB board and stencil, need adjust Swing adjusting handle (8), adjust the boltheight on Platform support base block(10) to make the Platform (4) even without shaking.4) Using the blade to scrape the solder paste (Squeegee angle of blade and steel stencil should be between 30 degrees to 75degrees)5) Clean the stencil regularlyPacking List:1 x Pinter1 x Manual